Park Pilot sensor harness too short
#1
Park Pilot sensor harness too short
After reading the park pilot threads I ordered the base kit and two sets of grey sensors. The grey sensors match the paint perfectly but the wires attached to the sensors are much too short (about 18") to reach the control module. Also, the connector on the end of the sensor wire does not fit into the control module connector. Is there an extension harness? One of the install manuals I came across references part number 250-2664 but I don't see that (or anything similar) available on the Brandon Distributing website where I purchased the kit. Any ideas?
Thanks!
Thanks!
Thread
Topic Starter
Forum
Replies
Last Post
fitteacher
Mercury Mariner Hybrid
1
10-09-2009 09:07 AM
Jason
Journalism & The Media
0
05-24-2005 12:30 PM