How "Unlock Connector" feature is implemented
#1
11-03-2021, 03:46 AM
How "Unlock Connector" feature is implemented
Hello,
In the OCPP specification there is "Unlock Connector".
How it works ?
I suppose that upon receiving the "Unlock Connector" command through OCPP, a charger should send a command to the connector through the CAN bus. If this is correct, where can I find information on how to create such a CAN message.
One more question - this feature be implemented on all types of connectors (i.e. Type 2, CHAdeMO, Combo2, etc.) or only on particular ones ?
Thanks in advance.
Sincerely,
Pavel.
In the OCPP specification there is "Unlock Connector".
How it works ?
I suppose that upon receiving the "Unlock Connector" command through OCPP, a charger should send a command to the connector through the CAN bus. If this is correct, where can I find information on how to create such a CAN message.
One more question - this feature be implemented on all types of connectors (i.e. Type 2, CHAdeMO, Combo2, etc.) or only on particular ones ?
Thanks in advance.
Sincerely,
Pavel.
Thread
Topic Starter
Forum
Replies
Last Post
ntguru
Toyota Camry Hybrid
3
09-23-2007 04:00 PM
